Circuitpal Open the simulator

Electronics simulator

Build the circuit. See why it works.

Circuitpal runs in your browser. Draw a schematic or build on a 3D breadboard, press Run, and watch the current, the voltages and the heat.

The 3D workbench running: a 555 timer on a breadboard flashes a glowing red LED, with resistors, a capacitor and jumper wires.
Running now: a 555 timer flashing an LED, on the 3D workbench

Try it

Feel Ohm's law in your hands

This circuit is live. The resistor takes whatever voltage the LED does not use, so the current is 7 volts divided by the resistance.

  1. Close the switch and watch the LED light.
  2. Make the resistor smaller: more current, a brighter LED.
  3. Go below 233 Ω and a real LED would burn out. Try it; a new one is free.
Learn this in the simulator
A 9 volt battery, a switch, a resistor and an LED in a loop The current, the resistor colour bands and the LED brightness change as you move the slider. +9 V− Switch 470 Ω LED
470 Ω
0 mAcurrent
0.0 Vacross the resistor
0.0 Vacross the LED
0 mWheat in the resistor

Press the switch to close the circuit.

Two ways to build, one click apart

Draw it like a textbook, or build it like the real thing. Switch between them whenever you like.

The 3D workbench: a 555 timer circuit on a breadboard with a glowing LED.
A breadboard at its real size.Legs snap into holes, LEDs glow, and a wrong connection behaves the way it would on your desk.

Learn by building

Guided lessons watch the circuit you build and tick off each step. Challenges give you a goal to reach, or a faulty circuit to repair.

Browse the lessons
  1. 01Light your first LED10 min
  2. 02Voltage and the voltmeter8 min
  3. 03See a signal with the oscilloscope10 min
  4. 04Dim an LED with a potentiometer10 min
  5. 05Logic gates: AND, NOT, OR and NAND32 min
  6. 06Protect a circuit with a fuse10 min

Physics that goes deeper, when you ask for it

The advanced simulations are off until you switch them on. They are approximations, built from the textbook equations.

Heat and airflow

Hot parts warm the air around them, sensors feel it, a fan cools them. Seal it in a box and watch it heat up.

Magnets and metal

Magnets pull and turn each other, and pull on steel. A coin dropped across two legs really shorts them.

Propellers

A blade-element model, checked against measured wind-tunnel data of real propellers.

Real materials

Weight, friction and bounce from what a part is made of, plus gravity and wind if you want them.

Tools for the next step

Once the basics click, there is room to grow.

Measure and analyse

An oscilloscope, Bode plots, sweeps, Monte Carlo runs and SPICE export, for when you want numbers and not just a picture.

Real chips and displays

555 timers, logic gates and op-amps, a Raspberry Pi Pico you program in Python, and LCD, OLED and TFT screens.

Your work stays yours

Circuits are saved in your browser and in files you export. Nothing is uploaded unless you choose to share it. No ads, no tracking.

Pick up a component and start.

The simulator opens straight to a working circuit. Press Run and click the switch.

Open the simulator