Examples
48 ready-made circuits. Open the Examples menu at the top and pick one.
Each example loads a complete circuit that you can run, change and learn from. Many work in both the schematic and the 3D view.
- LED + resistor + switch
- Potentiometer dimmer
- RC charging
- Half-wave rectifier with smoothing capacitor (scope)
- Zener voltage regulator
- Night light (LDR + transistor)
- Signal generator blinking an LED
- Transistor switch (NPN)
- 555 LED flasher
- Logic gate (AND)
- Binary counter
- 7-segment display (switches)
- Breadboard: LED circuit
- Breadboard: 74HC00 NAND chip
- Perfboard: LED circuit (solder traces)
- Oscilloscope: square wave through an RC filter
- Tolerances: a voltage divider that is not exactly 2.5 V
- Trampoline: a ball bouncing on a mat (3D physics)
- Gears: two reductions and a self-locking winch
- Gears: a motor driving a fan through a gear pair
- Motor + gearbox: automatic lift
- Motor: fan with a speed knob
- Thermistor divider (ambient temperature)
- TMP36 temperature sensor
- Resistor that overheats and burns
- Counter + decoder + 7-segment (74xx chips)
- 74HC00 NAND chip (4 gates)
- Microcontroller: Blink
- Microcontroller: Button → LED
- Microcontroller: button interrupt (INT0)
- Microcontroller: EEPROM boot counter
- Microcontroller: Fade (PWM)
- Microcontroller: Pot → LED + Serial
- Microcontroller + 16×2 LCD
- Microcontroller + OLED
- Microcontroller + TFT screen
- Microcontroller: 7-segment counter
- Pico (Python): Blink
- Pico (Python): Button → LED
- Pico (Python): PWM fade
- Pico (Python): Pot → LED + print
- Pico (Python): read a TMP36 temperature sensor
- Pico (Python): OLED over I²C
- Pico (Python): TFT over SPI
- Pico (Python): 16×2 LCD
- ESP32: Blink
- ESP32: Pot → PWM LED + Serial
- ESP32 + OLED