Troubleshooting and questions
Quick answers to the things people run into.
"3D mode could not start"#
- Reload the page without the cache: press Ctrl+Shift+R (Cmd+Shift+R on a Mac). After an update, a browser can keep running an older copy of some files.
- A browser extension may be blocking files. Ad blockers and privacy shields sometimes block files they misjudge. Try turning the extension off for this site, or open the site in a private window.
- WebGL must be on. Visit your browser's graphics settings and make sure hardware acceleration is enabled.
It is slow or the fans spin up#
See Graphics quality and speed: choose Low quality and close other tabs.
I lost my circuit#
Designs are saved in this browser. They disappear if you clear the site's data, use a private window, or switch computers. Use Open to look for saved designs, and Export files to keep copies. See Saving, files and sharing.
Nothing happens when I press Run#
- Is there a Ground? Every circuit needs one.
- Is the loop closed, with every wire attached to a pin or a hole (a connected wire end shows a dot)? Hover a wire to see what it connects.
- Is a switch open? Click it.
- On a breadboard, are the legs in the same column as the wire or part they should connect to?
The LED burned out#
An LED needs a resistor in series. A resistor of a few hundred ohms is typical on a 5 to 9 volt supply: see the first circuit.
Questions#
Is it free? Yes. Do I need an account? No. Does it work on a phone? The schematic sheet and lessons do; the 3D workbench works best on a computer. Where do my circuits go? Only to your own browser, unless you choose to share one. Can I use it offline? Not at the moment.
Still stuck?#
Use the Suggestions box at the bottom of Settings, or contact the developer through github.com/Pok8TheCoder.