Open the simulator

Your first circuit

A battery, a resistor and an LED: the "hello world" of electronics. It takes about five minutes.

On the schematic sheet#

  1. Open the simulator. It starts on the 2D schematic sheet.
  2. From the parts list on the left, drag a Power source onto the sheet. Do the same for a Resistor, an LED and a Ground. Use the search box at the top of the list (press /) if you cannot find one.
  3. Wire them in a loop. Drag from a pin (the small circle at the end of a part) to a pin on the next part: battery + to the resistor, the resistor to the LED anode, the LED cathode to the battery −. Connect the Ground to the battery −.
  4. Press Run at the top. The LED lights and the status shows the running time.
  5. Click the resistor. The panel on the right shows its value and the live current. Change the resistance and watch the LED get brighter or dimmer.

The quick way: an example#

Open the Examples menu at the top and choose LED + resistor + switch. Press Run, then click the switch on the sheet to turn the LED on and off.

On the 3D workbench#

  1. Click 3D at the top.
  2. Drag a Breadboard from the parts list onto the bench, then drag an LED and a resistor onto it. Their legs snap into the holes.
  3. Add a Power source. Choose the Wire tool at the bottom and click from a battery terminal to a hole to run a jumper wire.
  4. Press Run.

Holes in the same column (a to e, or f to j) are connected, and the long rails along the edges run the whole length of the board, like the real thing. See The 3D workbench.

Want to be walked through it?#

Open Lessons at the top and start Light your first LED. It watches the circuit you build and ticks off each step. See Lessons and challenges.