Lessons and challenges
Learn by building. Lessons guide you step by step; challenges give you a goal or a fault to find.
Lessons#
Open Lessons in the top bar and pick one. A lesson shows one step at a time, points at what to do, and checks the circuit you build: when a step is done it ticks itself and moves on. Each step explains why it works. You can leave at any time and come back. Lessons you finish get a tick on the lesson list.
| Lesson | Where | Time | Steps |
|---|---|---|---|
| Learn the tools (3D workbench) | 3D workbench | 4 min | 15 |
| Learn the tools (schematic sheet) | Schematic sheet | 4 min | 15 |
| Light your first LED | 3D workbench | 10 min | 13 |
| See a signal with the oscilloscope | 3D workbench | 10 min | 11 |
| Meet the components | Schematic sheet | 8 min | 11 |
| Voltage and the voltmeter | Schematic sheet | 8 min | 10 |
| Logic gates 1: the AND gate | Schematic sheet | 10 min | 7 |
| Logic gates 2: the NOT gate | Schematic sheet | 10 min | 12 |
| Logic gates 3: OR and NAND | Schematic sheet | 12 min | 8 |
| Dim an LED with a potentiometer | 3D workbench | 10 min | 9 |
| Protect a circuit with a fuse | 3D workbench | 10 min | 11 |
The two Learn the tools lessons are the quickest way to find your way around the real toolbar.
Challenges#
Open Challenges in the top bar. A build challenge gives you a goal (for example: light the LED safely, or make 9 volts into 3). A debug challenge starts with a faulty circuit that you must repair. The simulator checks your answer.
| Challenge | Kind |
|---|---|
| Light the LED safely | Build to a goal |
| 9 volts down to 3 | Build to a goal |
| A gentle breeze | Build to a goal |
| The dead LED | Repair a fault |
| The sneaky short | Repair a fault |
| The overheating resistor | Repair a fault |
Lessons from other people#
When the Community page is on, people can share their own lessons and challenges. They are made of steps and checks only, so opening one is always safe.