Measuring and analysing
Meters, an oscilloscope, a signal generator and analysis tools.
Voltmeter and ammeter#
Add a Voltmeter (across two points) or an Ammeter (in the path of the current) from the Meters group. They show the live reading. Clicking any part also shows its voltage and current in the details panel.
Oscilloscope#
Add an Oscilloscope and wire its channels to the signals you want to see. Its panel opens below the sheet.
| Control | What it does |
|---|---|
| Autoset | Picks a time and voltage scale that fit the signal. |
| Time | Time per division (for example 5 ms/div). |
| CH1, CH2 | Volts per division for each channel. |
| Cursors (under More) | Drag A and B to read a time constant or a frequency off the trace. |
| Stop | Freezes the trace so you can study it. |
The scope sees signals up to 1 ÷ (10 × the time step), so lower the Step at the top for faster signals. Try the example Oscilloscope: square wave through an RC filter.
Signal generator#
The Signal generator (in Sources) makes square, sine and other waves at a frequency and amplitude you set.
Analysis#
The Analysis button opens tools for looking at a circuit across many conditions instead of one run:
- Bode plot: how the gain and phase change with frequency (filters, amplifiers).
- Sweeps: step a value (a resistor, a voltage) and plot the result.
- Monte Carlo: run the circuit many times with random component tolerances, to see how much the result varies.
- SPICE: export the schematic as a netlist for other tools, or import a netlist.
Real-world imperfections#
By default parts are ideal. In the details panel, Tolerances and noise gives every part its own small fixed random error (for example resistors within ±5 %, capacitors and inductors within ±10 %) and adds a little noise. New batch draws a fresh set of errors. The Environment temperature slider changes temperature-dependent parts such as thermistors and sensors.