The 3D workbench
Build circuits on a real-size breadboard, with parts that look and behave like the real ones.
Boards#
Add a Breadboard or a Perfboard from the parts list. Parts you drop near holes snap their legs into them.
- Breadboard: holes in a column are connected (a to e, and f to j, with the centre channel between). The rails along the top and bottom run the whole length, like on a real board.
- Perfboard: every hole is separate. Join holes with a wire between them, which becomes a flat solder trace.
- Chips (a 555, flip-flops, counters, displays) straddle the centre channel so each pin gets its own column.
Jumper wires#
Choose the Wire tool at the bottom, then click a battery terminal, a leg or a hole, and click the place it should go. Pick a wire colour in the bottom bar before you draw. Hover a leg to see the pin's name.
Moving the camera#
| Action | How |
|---|---|
| Slide the view | Drag empty space with the left button |
| Turn the view | Middle-button drag, or Alt + drag, or two fingers on a trackpad or touch screen |
| Zoom | Mouse wheel or pinch. Hold Ctrl for fast, Shift for fine |
| Fly | W A S D to move, Space up, Shift down |
Moving and turning parts#
Click a part for its details. Drag it to move it. Use the Rotate and Flip buttons in the bottom bar (or R, Shift+R and F) to turn a part, or flip it over to see its back. Switches are clicked to toggle. The Move and Sphere buttons show handles for placing a part precisely.
Parts are solid: they stop at each other instead of overlapping. You can turn this off in Settings (Collisions).
Beyond circuits#
The bench can also run real physics (gravity, wind, magnets, heat), hold springs and cloth, and show imported 3D models. These are optional: see Advanced simulations.
How it looks#
The Light and Shadows buttons switch the lighting and shadows. If the bench is slow on your computer, see Graphics quality and speed.